SolidWorks Geeks

Problem with "driven line"

Hello.

I am following a videotutorial.

Doing the same as the guy teaching to model a Camera (Cadjunkie.com).

But the draw doesn't look like the one in the video. Don't know why I did THE SAME as the guy but 1 dimension is not specified in the video.

When I try to change it the SW says:  "this is a driven line" 

HELP!HELP! 

Thanks a lot!

Views: 31

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by BS on January 23, 2012 at 3:45pm

Why I can see this my post inside the forum?!

Permalink Reply by Saitakis Emmanuel on January 24, 2012 at 4:19am

because you have already fully define your sketch, with the dimensions you already placed (the distance at left: 1mm, and the radius25). With the current data you imported, the distance at top, should be 0.25. In order to be able to change the 0.25, you must delete one of the other dims (distance at left, or the radius). Otherwise, you can make the 0.25 a driven dimension.

Permalink Reply by BS on January 27, 2012 at 1:38pm

The dim I want to change isn't 0.25. The dimension which is wrong is the lenght no the distance on the Y axis. Thanks!

▶ Reply to Discussion

RSS

Connect to other SolidWorks Geeks throughout the world.... Share tips, tricks and ideas...Learn to master SolidWorks.

Birthdays

Birthdays Today

Birthdays Tomorrow

© 2012   Created by Alex R. Ruiz.   Powered by

Badges  |  Report an Issue  |  Terms of Service

Sign in to chat!