Weldments
When adding a sheer member to a frame. How do I get the same angle at both ends of sheer member.
Views: 26
Replies to This Discussion
-
Permalink Reply by Deepak Gupta on -
Did you tried the Trim/Extend option in Weldments.
-
Permalink Reply by James eager on -
Yes, Let me clarify. You start with a sketch. Let say a 4x sq. Then you add a sheer member. Then you add your structrural members. When you structrual member the sheer member you can only locate profile on one end and to a liner edge of the member. So what i have been doing depending on time I go back to sketch and figure out the distance from the id of the sq members and move the sketch over. Is there a better way to do this. I fabrication it is best to have both ends of the sheer member cut to the same miter.
-
Permalink Reply by Deepak Gupta on
-
James, I'm little confused on what exactly you trying to clarify. Any example file which describes your problem will be great to understand the exact situation.
-
Permalink Reply by James eager on
-
In weld 1 is typ of weldments. In weld 2 is what i am asking. i am hoping that there ia a way to make this faster.
- Attachments:
-
-
~$weld 1.SLDPRT, 1 KB -
~$weld 2.SLDPRT, 1 KB
-
-
Permalink Reply by Deepak Gupta on
-
James, I have trouble opening these files. It seems you have uploaded the temp files by mistake. Can you upload the files again.
Connect to other SolidWorks Geeks throughout the world.... Share tips, tricks and ideas...Learn to master SolidWorks.
Birthdays
© 2012 Created by Alex R. Ruiz.
Powered by
